archi
2013-10-09, 17:18
Raspberry Pi
I have this dongle http://www.canyon-tech.com/products/connectivity/wireless/CNP-WF518N2
Realtek RTL8188SU
Following by realtek instructions(I downloaded drivers from realtek not from canyon, 8188su) to edit Makefile it says you can create new CONFIG_PLATFORM_NEWxxx = y
What CONFIG_PLATFORM_NEW = y name is for Raspberry Pi(something like CONFIG_PLATFORM_ARM_PXA2XX) does name makes difference?
Next I need to add this
ifeq ($(CONFIG_PLATFORM_NEWxxx), y)
EXTRA_CFLAGS += -DCONFIG_LITTLE_ENDIAN
ARCH := arm
CROSS_COMPILE := /opt/new/toolchain/arm-eabi-4.4.3/bin/arm-eabi-
KSRC := /opt /new/kernel
endif
What I should write here = CROSS_COMPILE - KSRC??
When I have saved file I can execute make, it will generate .ko file
then I can install it like this insmod 8712u.ko?
Will it be loaded and ready to go, or I need to do something additional?
I have this dongle http://www.canyon-tech.com/products/connectivity/wireless/CNP-WF518N2
Realtek RTL8188SU
Following by realtek instructions(I downloaded drivers from realtek not from canyon, 8188su) to edit Makefile it says you can create new CONFIG_PLATFORM_NEWxxx = y
What CONFIG_PLATFORM_NEW = y name is for Raspberry Pi(something like CONFIG_PLATFORM_ARM_PXA2XX) does name makes difference?
Next I need to add this
ifeq ($(CONFIG_PLATFORM_NEWxxx), y)
EXTRA_CFLAGS += -DCONFIG_LITTLE_ENDIAN
ARCH := arm
CROSS_COMPILE := /opt/new/toolchain/arm-eabi-4.4.3/bin/arm-eabi-
KSRC := /opt /new/kernel
endif
What I should write here = CROSS_COMPILE - KSRC??
When I have saved file I can execute make, it will generate .ko file
then I can install it like this insmod 8712u.ko?
Will it be loaded and ready to go, or I need to do something additional?