secjunkie
2014-09-27, 08:43
Hello all,
Device: Nexus 7 2012
OS: built from stock 4.4
my whole install process is recoreded (here (http://www.securityjunkie.co.uk/2014/09/kali-nethunter-part-1.html)) but I diont think you would need that much detail..
The onboard wireless device is enabled on the device and is not connected to any AP
The issue is that when I start up wifite I get:
error: SIOCGIFFLAGS (no such device)
wifite looks for wireless devices and finds
1. p2p0 unknown bcmsdh_sdmmc
2. wlan0 unknown bcmsdh_sdmmc
at this point i can select either one and it will say
enabling monitor mode on wlan0/p2p0... done
but it will bring me back to the selection list
[+]select number of device to put into monitor mode
in a seperate console if I run
ip a
I can see that mon0 and mon1 were created... yet im stuck in the infinite loop forced to break with Ctrl+c :(
Any help will be much appreciated.
Many thanks in advance.
Device: Nexus 7 2012
OS: built from stock 4.4
my whole install process is recoreded (here (http://www.securityjunkie.co.uk/2014/09/kali-nethunter-part-1.html)) but I diont think you would need that much detail..
The onboard wireless device is enabled on the device and is not connected to any AP
The issue is that when I start up wifite I get:
error: SIOCGIFFLAGS (no such device)
wifite looks for wireless devices and finds
1. p2p0 unknown bcmsdh_sdmmc
2. wlan0 unknown bcmsdh_sdmmc
at this point i can select either one and it will say
enabling monitor mode on wlan0/p2p0... done
but it will bring me back to the selection list
[+]select number of device to put into monitor mode
in a seperate console if I run
ip a
I can see that mon0 and mon1 were created... yet im stuck in the infinite loop forced to break with Ctrl+c :(
Any help will be much appreciated.
Many thanks in advance.