Anti-Hero
2019-03-09, 23:42
I have flashed nethunter to the Gemini 4g but when I attempt to use airmon-ng I always get this error
Found phy0 with no interfaces assigned, would you like to assign one to it? [y/n] y
Error adding monitor mode interface: command failed operation not supported (-95)
Found phy1 with no interfaces assigned, would you like to assign one to it? [y/n] y
Error adding monitor mode interface: command failed: operation not supported (-95)
PHY interface Driver Chipset
ethtool failed...
Only mac80211 devices on kernel 2.6.33 or higher are supported by airmon-ng
Any help greatly appreciated.
Using panda pau05 which comes up as wlan1 when using ifconfig wlan1 up
Found phy0 with no interfaces assigned, would you like to assign one to it? [y/n] y
Error adding monitor mode interface: command failed operation not supported (-95)
Found phy1 with no interfaces assigned, would you like to assign one to it? [y/n] y
Error adding monitor mode interface: command failed: operation not supported (-95)
PHY interface Driver Chipset
ethtool failed...
Only mac80211 devices on kernel 2.6.33 or higher are supported by airmon-ng
Any help greatly appreciated.
Using panda pau05 which comes up as wlan1 when using ifconfig wlan1 up