Hi everyone,
This is my first post on this forum. I recently bought myself the Alfa AWUS036H from amazon and I have been having serious problems with it. I am running Kali through vmware 10 and I am able to plug in my Alfa AWUS036H and get the wireless interface up but it will not work. Here's what I mean:
when i type ifconfig I get this:
eth0 Link encap:Ethernet HWaddr 00:0c:29:b6:b8:e1
inet addr:192.168.134.128 Bcast:192.168.134.255 Mask:255.255.255.0
inet6 addr: fe80::20c:29ff:feb6:b8e1/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:55 errors:0 dropped:0 overruns:0 frame:0
TX packets:26 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:5738 (5.7 KB) TX bytes:2615 (2.6 KB)
Interrupt:19 Base address:0x2024
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:15 errors:0 dropped:0 overruns:0 frame:0
TX packets:15 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:953 (953.0 B) TX bytes:953 (953.0 B)
wlan0 Link encap:Ethernet HWaddr 98:3f:9f:21:94:52
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
So it is able to detect it... but when I try a iwlist scan:
lo Interface doesn't support scanning.
wlan0 Failed to read scan data : No such device
eth0 Interface doesn't support scanning.
So the card crashes. I have tried installing THREE different drivers but of course they did not install correctly because i have very bad luck.
The next thing i noticed about the card was that its chipset is wrong. I bought the Alfa AWUS036H and it was supposed to come with the Realtek 8187 2.0 USB 56.0 mbps but instead I got the Ralink 2870/3070...
I don't know why this is and I have googled it and no one else seems to have this issue. Anyway, the card is able to get into monitor mode and scan for networks but the second I try and send a DEAUTH packet the card crashes again. I have tried setting it to max power and I am able to run iwlist scan but then the card crashes if i try and do it again. Really pissed at Alfa right now and would appreciate any help from you guys.