Connect Kali to the internet w/ VMware Fusion

[w0lverine00x90]

I am having difficulty connecting my kaili vm box to the internet

Troubleshooting I have tried:

Network adapter is set to "auto detect"
Went into the /etc/network/interface and changed the Ip address, broadcast, and mask to my respective IPs in my home network that is connected to the internet.
I still cannot ping my router or computer.

I might have something wrong with my virtual network adapter? Do I need to add a new virtual adaptor and a new "eth1" in my kali?

Any suggestions will help!!

[w0lverine00x90]

UPDATE: PROBLEM SOLVED:
I have the option turned on for my computers to use ipv6 and I set my /etc/network/interfaces to a static ipv4 address... with the subcomponents address, netmask, network, broadcast, .... Yes a few too many details I only needed the subcomponents address netmask and gateway but I did not go that far due to using the following:
auto eth0
allow-hotplug eth0
iface eth0 inet dhcp

[maverik35]

Your interfaces file must look like this:

# ethernet interface
iface eth0 inet static
address
netmask
network
broadcast
gateway

If you want to add the lo (local) interface in case of connection tests and host identification add this, but is not necessary to connect to the network.

#lo interface
auto lo
iface lo inet loopback

# Interfaz FastEthernet
iface eth0 inet static
address IP_Interfaz
netmask IP_mascara
network IP_Red
broadcast IP_Difusión
gateway IP_Router

Luck.