Results 1 to 4 of 4

Thread: Running "airmon-ng start wlan0" command

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Running "airmon-ng start wlan0" command

    When i run the "airmon-ng start wlan0" command these are the results i get

    PHY Interface Driver Chipset

    phy0 wlan0 wl Broadcom Corporation BCM43142 802.11b/g/n (rev 01)

    (experimental wl monitor mode vif enabled for [phy0]wlan0 on [phy0]prism0)

    Why does it say "experimental wl monitor mode" is this an issue because i have been trying to crack a WPA password and had no success even after leaving my command running for 24hrs.

  2. #2
    Join Date
    2013-Apr
    Location
    Kali forums
    Posts
    805
    Not a message I have seen before, but what happens when you do an injection test with aireplay-ng? Are you collecting packets when using airodump-ng?

    If you can inject, and are collecting packets, I'd say just ignore the message.

  3. #3
    Hey grid, thank you for the reply.

    I have found out that the network card i have, "BCM43142" does not support monitor mode but it was attempting to run.

    Recently i have purchased an external USB network card that supports Kali, the network device is a ALFA AWUS051NH, the actual network chip is a Ralink Technology, Corp. RT3572. But unfortunately i am still having issues.. when I run reaver and attempt to crack WIFI this is the message i receive "WARNING: Receive timeout occurred Sending EAPOL START request" this repeats infinitely.

    The device has no problem entering monitor mode and is recommended for Kali so i am really confused by this situation. If you could provide any expert knowledge on this subject it will be greatly appreciated!
    Last edited by Cryptic-F; 2016-04-15 at 02:59.

  4. #4
    check that AP with -c option to see the rxq you have. low rxq=lot of warnings. also see the --wps command. if it's PBC, forget it. Happy.. attempts

Similar Threads

  1. Replies: 1
    Last Post: 2021-02-11, 20:00
  2. Replies: 1
    Last Post: 2020-07-02, 12:15
  3. Replies: 8
    Last Post: 2015-12-16, 18:48

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •