PwnSTAR not recognising wlan

[Matriculate]

I think this is a general issue over my kali system as it has happened with other scripts too.
In pwnstar i am trying to set up a captive portal but here is the outcome;

Available interfaces:
eth0:   
ether   (Ethernet)
ether   (Ethernet)
ether   (Ethernet)
wlan0:   
wlan1:   

Enter internet connected interface
wlan0

Macchanging wlan0...
Current MAC:   [mac address] (Intel Corporate)
Permanent MAC: [mac address] (Intel Corporate)
New MAC:       00:90:3e:34:43:75 (N.V. PHILIPS INDUSTRIAL ACTIVITIES)

You need to reconnect internet
(ignore networkmanager applet)

       DO IT NOW


If having problems, RESTART networking in nm-applet, or use Wicd

Available wireless interfaces:
wlan0:   
wlan1:   

Wireless interface to use for AP?
wlan1

Starting monitor mode...

Best to macchange wlan1 and ...

Random MAC? (y). Or manual (m)
y
Current MAC:   [mac address] (EDUP INTERNATIONAL (HK) CO., LTD)
Permanent MAC:[mac address] (EDUP INTERNATIONAL (HK) CO., LTD)
New MAC:       00:1b:aa:4e:f6:bb (XenICs nv)
down: error fetching interface information: Device not found

wlan0 does have internet access and wlan1 does exist, when i run airmon-ng i get;

PHY	Interface	Driver		Chipset

phy0	wlan0		iwlwifi		Intel Corporation Centrino Advanced-N 6200 (rev 35)
phy1	wlan1		rtl8192cu	Realtek Semiconductor Corp. RTL8188CUS 802.11n WLAN Adapter

iwconfig shows;

wlan0     IEEE 802.11abgn  ESSID:"Wifi"  
          Mode:Managed  Frequency:2.462 GHz  Access Point: {Shows Address}   
          Bit Rate=6.5 Mb/s   Tx-Power=15 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=69/70  Signal level=-41 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:43   Missed beacon:0

lo        no wireless extensions.

eth0      no wireless extensions.

wlan1     IEEE 802.11bgn  ESSID:off/any  
          Mode:Managed  Access Point: Not-Associated   Tx-Power=20 dBm   
          Retry short limit:7   RTS thr=2347 B   Fragment thr:off
          Encryption key:off
          Power Management:off

This results in no AP broadcast and pwnstar thinking that wlan0 isn't connected to the internet.

Any advice on fixing ?