Hey people,
I guess you can try anything for the same problem:
For that example, i use "wifite"
Some times, when you make ( wifite -i wlan1mon) for example.. the card is ON and after a few seconds going to OFF...! Disturbing!
So, i can use normally wifite BUT, you need have some factors in mind:
1: lsusb (If your external card appear ok, maybe .... usb atheros.. etc etc go to job if not check usb cable, remember OTG!!)
1: First make a ( airmon-ng ) and you see all your WIFIcards.. if you use a OTG usb cable.. no problem:
phy73 psp0 XXXXXXXX
phy73 wlan0 XXXXXXXX
phy72 wlan1 xxxxxxxxxx
2: Make monitor mode: ( airmon-ng start wlan1 ) ... BUT warning::
maybe the airmon-ng says some like this: " Some process can cause problems with WPA_SUPPLICANT troubleshooting kill this..."
and look the attached process like this: 13898 WPA_SUPPLICANT
So, kill the process and free the external wifi, {dummy but: (kill -9 13898)}
With that problem resolved again make a monitor mode:
airmon-ng start wlan1
and
wifite -i wlan1mon
Everything is work, i test this process a lot of times.... connected and disconnected the external wifi, an ever WORKS!!!
I think (just suppose) the problem is in wpa_supplicant ever, maybe cause a conflict with the atheros wifi.
Any comments are welcome.
#HappyHacking
nethunter.JPG