hi all
i tried to start my access point to perform Evil Twin Attack
but there is a problem with hostapd and i don't know how to solve it
i used airmon-ng check kill
but didn't worked ...
here is the detail :
Code:
root@kali:~/Desktop# uname -a
Linux kali 5.2.0-kali2-amd64 #1 SMP Debian 5.2.9-2kali1 (2019-08-22) x86_64 GNU/Linux
root@kali:~/Desktop# lsusb
Bus 003 Device 002: ID 0781:5590 SanDisk Corp. Ultra Dual
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 008 Device 003: ID 0a12:0001 Cambridge Silicon Radio, Ltd Bluetooth Dongle (HCI mode)
Bus 008 Device 002: ID 25a7:fa23 Compx 2.4G Receiver
Bus 008 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 007 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 006: ID 0cf3:0001 Qualcomm Atheros Communications AR5523
Bus 001 Device 002: ID 058f:6362 Alcor Micro Corp. Flash Card Reader/Writer
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
root@kali:~/Desktop# airmon-ng check
Found 2 processes that could cause trouble.
Kill them using 'airmon-ng check kill' before putting
the card in monitor mode, they will interfere by changing channels
and sometimes putting the interface back in managed mode
PID Name
1677 NetworkManager
2169 wpa_supplicant
root@kali:~/Desktop# ifconfig
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.0.102 netmask 255.255.255.0 broadcast 192.168.0.255
inet6 fe80::fb60:32ed:424f:1eb5 prefixlen 64 scopeid 0x20<link>
ether 90:e6:ba:01:5b:3d txqueuelen 1000 (Ethernet)
RX packets 76306 bytes 70164457 (66.9 MiB)
RX errors 0 dropped 3 overruns 0 frame 0
TX packets 62986 bytes 7790440 (7.4 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 740 bytes 55200 (53.9 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 740 bytes 55200 (53.9 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlan0mon: flags=803<UP,BROADCAST,NOTRAILERS,PROMISC,ALLMULTI> mtu 1500
ether 00:21:27:c3:1c:9c txqueuelen 1000 (Ethernet)
RX packets 7033 bytes 1573094 (1.5 MiB)
RX errors 0 dropped 1453 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
root@kali:~/Desktop# iwconfig
wlan0mon IEEE 802.11 ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
lo no wireless extensions.
eth0 no wireless extensions.
ERROR :
Code:
root@kali:~/Desktop# hostapd hostapd.conf
Configuration file: hostapd.conf
nl80211: Could not configure driver mode
nl80211: deinit ifname=wlan0mon disabled_11b_rates=0
nl80211 driver initialization failed.
wlan0mon: interface state UNINITIALIZED->DISABLED
wlan0mon: AP-DISABLED
wlan0mon: CTRL-EVENT-TERMINATING
hostapd_free_hapd_data: Interface wlan0mon wasn't started