When I switch to monitor mode wifi connection lost and no traffic goes through airodump. Does it means my chipset not support monitor mode or do I have to get another external one so one will be used to connect to wifi and another ti sniff in monitor mode?
Available interfaces
Code:
root@kali:/home/kali# ifconfig
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 28 bytes 1700 (1.6 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 28 bytes 1700 (1.6 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.0.108 netmask 255.255.255.0 broadcast 192.168.0.255
inet6 fe80::6335:e346:d52a:fd84 prefixlen 64 scopeid 0x20<link>
ether 3c:95:09:ef:e7:7d txqueuelen 1000 (Ethernet)
RX packets 7 bytes 1830 (1.7 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 10 bytes 1546 (1.5 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Chipset
Code:
root@kali:/home/kali# lspci | grep Net
02:00.0 Network controller: Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter (rev 32)
I use airmon-ng to switch into monitor mode like so. And after I switched I lose Internet connection
Code:
root@kali:/home/kali# airmon-ng check kill
Killing these processes:
PID Name
1210 wpa_supplicant
root@kali:/home/kali# airmon-ng start wlan0
PHY Interface Driver Chipset
phy0 wlan0 ath10k_pci Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter (rev 32)
(mac80211 monitor mode vif enabled for [phy0]wlan0 on [phy0]wlan0mon)
(mac80211 station mode vif disabled for [phy0]wlan0)
When I switch to monitor mode output of ifconfig:
Code:
root@kali:/home/kali# ifconfig
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 28 bytes 1700 (1.6 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 28 bytes 1700 (1.6 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlan0mon: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
unspec 3C-95-09-EF-E7-7D-30-3A-00-00-00-00-00-00-00-00 txqueuelen 1000 (UNSPEC)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Then I finally try run airodump-ng which gives nothing at all, no traffic, empty table. Also tested with wireshark, still no traffic and no internet connection
Code:
root@kali:/home/kali# airodump-ng wlan0mon