Hello!I recently installed Kali Linux as a second operating system (the first is Windows 10) according to the instructions.(https://hackware.ru/?p=6360 - Similar instructions). Next, I needed to configure my network adapter (AWUS036AC with Realtek RTL8812AU chipset) on my Kali Linux (Since the network adapter worked on Windows 10 without any comments and driver installations).After repeated and unsuccessful attempts to install the drivers on the network adapter (again, according to various instructions - here's an example: https://**********6Vs0GH9oxSs), I came to the conclusion that most likely it is a wired connection. Some unusual interface: The Wired icon is not displayed in the upper right corner, as well as the settings icon to customize the whole thing.
Only the Wi-fi network icon is displayed. Ifconfig doesn't show Eth0. I also notice that usb works strangely: When the mouse is connected before Kali is loaded, it works, if during operation the mouse is disconnected from usb and turned back on, the mouse does not respond.
In one of the ways to install drivers, after the make command, the terminal gives an error:error: ?_timer? {aka ?struct timer_list?} has no member named ?data? 254 | ptimer->data = (unsigned long)cntx;
| ^~
error: ?_timer? {aka ?struct timer_list?} has no member named ?data?
254 | ptimer->data = (unsigned long)cntx;
| ^~
error: ?_timer? {aka ?struct timer_list?} has no member named ?data?
254 | ptimer->data = (unsigned long)cntx;
| ^~
make[1]: *** [/usr/src/linux-headers-5.7.0-kali1-common/Makefile:180: sub-make] Ошибка 2
make[1]: выход из каталога ?/usr/src/linux-headers-5.7.0-kali1-amd64?
make: *** [Makefile:1051: modules] Ошибка 2
If you have any suggestions, please write. Thank.There was only one error during installation: Missing firmware file: regulatory.db. I ignored this problem.Hello!I recently installed Kali Linux as a second operating system (the first is Windows 10) according to the instructions.(https://hackware.ru/?p=6360 - Similar instructions).There was only one error during installation: Missing firmware file: regulatory.db. I ignored this problem.