Kali 2.0 on Raspberry Pi with Adafruit 3.5" PiTFT - Help
I'm trying to get Kali 2.0 installed and working on my original Raspberry Pi (model B) with an Adafruit 3.5" PiTFT display.
I've searched the internet and found nothing that works. There are a couple of posts on this forum that relate in part. The post about the same issue, but with a 2.8" PiTFT which ended up with one of the admins creating an image for it. I tried using that image and it doesn't seem to work with the 3.5" display. I've looked for where some setting might be related to the display that I might change to get it to work with the 3.5" display, to no avail.
If anyone could offer any help, I would appreciate it.
Thanks!
7.0" 40-Pin TFT Display - 800x480
I have a 7.0" 40-Pin TFT Display - 800x480 connected to the kippah wich is pluged to the pi 3 using the 40 pins setup as follow :
https://learn.adafruit.com/adafruit-...l-tft/overview
I followed all the steps here :http://whitedome.com.au/re4son/sticky-fingers-kali-pi/
and when I want to setup the screen I enter :
./re4son-pi-tft-setup -t pi70 -d /root cause its the only 7.0" listed ,but it still not working .
How do I do to setup this particular screen ?
Quote:
Originally Posted by
re4son
Hi hossein3soot,
what does your /boot/config.txt look like? Can you see multiple "Re4son" configuration blocks? If so, just delete it all and run setup again for the wave35.
If it still doesn't work, find the line:
dtoverlay=waveshare35a,speed=32000000,fps=50,rotat e=90
in your /boot/config.txt and remove the "speed=32000000,fps=50," bit
That should work.
Good luck,
Re4son