ra0 is on channel 1, but the AP uses channel 2

Hello, I'm having this problem and am quite suspicious about the adapter (Ralink MT7601U)
Here's a screenshot
Attachment 1307

I tried changing channel/mode as shown in screenshot below :
Attachment 1308
Didn't work :(

Any help?
Thanks in advance

read this post
https://forums.kali.org/showthread.p...ng-for-Support
maybe it could be helpful

I have already installed the driver, and it also shows on airmon-ng/airodump
the problem is with aireplay, it has a different channel (u can see it in 1st screenshot "fixed channel 1") than AP (channel 2)
So, I want to change the channel of my ra0, but haven't yet found a way...

Igli1, I notice I get that same error if I don't do a -c in the
airodump-ng -c (same channel as the --bssid I'm trying to crack) --bssid (Mac) wlan1mon

So if your target is on channel 7

Airodump-ng -c 7 --bssid 22:33:44:55:66:77 wlan1mon

Then when I do aireplay it works.

Thanks for the help but it doesn't work

like in kali 1 happened to me, turn down wlan0 to stabilise your channel. without airmon-ng check kill, sometimes those processes interfere with monitor modes.

It said again after turning it off "ra0 is in channel 1, but the AP uses channel x (2, 3 or whatever)"
I still need a way to figure how to change fixed channel (in my case 1)

Someone can help?

i have same problem. i searching to fix it. i think i should reboot operating system. hehehe untill i find that problem's solution