im using a live usb and something i did managed to perminatly set the regionto BO even when i reboot it still said Tx-Power=30 dBm
Printable View
im using a live usb and something i did managed to perminatly set the regionto BO even when i reboot it still said Tx-Power=30 dBm
I have tried both option's but i still recieve the same error,
Is this maybe cause my wifi card can't support 20 + DPM?
I tried change it below 20 and it worked but if i try to set it 21 or higher i recieve the same error,
Where is regulatory.bin file located in kali? I fine only how-to for backtrack but kali seems to be different
I still get errors with option #2:
Quote:
root@Kali:~# ifconfig wlan0 down
root@Kali:~# iw reg set BO
root@Kali:~# ifconfig wlan0 up
root@Kali:~# iwconfig channel 13
iwconfig: unknown command "13"
root@Kali:~# iwconfig wlan0 channel 13
Error for wireless request "Set Frequency" (8B04) :
SET failed on device wlan0 ; Invalid argument.
root@Kali:~# iwconfig wlan0 txpower 30
Error for wireless request "Set Tx Power" (8B26) :
SET failed on device wlan0 ; Invalid argument.
root@Kali:~#
Code:root@kali:~# ifconfig wlan1 down
root@kali:~# iw reg set BO
root@kali:~# ifconfig wlan1 up
root@kali:~# iwconfig wlan1 channel 13
root@kali:~# iwconfig wlan1 txpower 30
Error for wireless request "Set Tx Power" (8B26) :
SET failed on device wlan1 ; Invalid argument.
I guess this doesn't increase the "Receiving" sensitivity of your device.
It seems to me I've found the solution.
You should do 'ifconfig <device> down' for all the wireless devices!
After all the wireless devices were down, you can make 'iw reg set BO' successfully! And 'iwconfig <scan_device> txpower 30' ;).
i new in kali and i want know if i can Increase Wi-Fi TX Power / Signal Strength of my wifi adaptar
my model is D link DWL G122 version 5.0
WE have run six AWUSO36H wifi recievers at 30 dBm constantly for over two years and have never had any problems. One country we ran it outside when free air temperatures were 48 degress C in the shade for months.
Hello,
If I follow these instructions for my Alfa AWUS036H happily shows the Tx Power increased up to 30.
The problem is, that it looks like the card stops working afterwards. a
airodump-ng doesn't catch any packet on any channel until I switch the country code back to the original '00'.
Any clues?
Thank you very much!