Bring WiFi "up" via command line
I have a wifi adapter that shows up when I type
As you can see here
Code:
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000
link/ether 26:12:4e:8d:eb:9f brd ff:ff:ff:ff:ff:ff
If I run I see a list of available WiFi networks. When I type
Code:
ip link set wlan0 up
it will not change the state from DOWN to UP.
How can I enable this Wifi Adapter through the command line? (I only have terminal access at this moment)
