After installing to partition, dual booting with winxp pro 64bit, I attempted to start the OS. I received the following errors

Selected Debian GNU/Linux, With Linux 3.7-trunk-amd64 at Grub loader

Code:
Booting the kernel.
Loading, please wait...
modprobe: can't load module microcode (kernel/arch/x86/kernel/microcode.ko): No such Device
INIT: version 2.88 booting
[ info ] Using makefile-style, concurrent boot to runlevel S.
[  ok  ] Starting the hotplug events dispatcher: edevd.
udevd[398]: specified group 'pcscd' unknown


[....] Synthetsizing the initial hotplug events...udevd[398] specified group 'pcscd' unknown


done.
[....] Waiting for /dev to be fully populated...[     5.672556] Bad IO access at port 0x2000 (outl(val,port))
[     5.673782] Bad IO access at port 0x2004 (outl(val,port))
[     5.674966] Bad IO access at port 0x2008 (outl(val,port))
[     5.676165] Bad IO access at port 0x200c (outl(val,port))
[     5.677345] Bad IO access at port 0x2010 (outl(val,port))
[     5.678525] Bad IO access at port 0x2014 (outl(val,port))
[     5.679705] Bad IO access at port 0x2018 (outl(val,port))
[     5.680897] Bad IO access at port 0x201c (outl(val,port))
[     5.682150] Bad IO access at port 0x2020 (outl(val,port))
[     5.683354] Bad IO access at port 0x2024 (outl(val,port))
Attempted to run Debian GNU/Linux, with Linux 3.7-trunk-amd64 (recovery mode) at Grub Loader
Received the following after a bunch of tracing (about 4 seconds was entirely too much to type)

Code:
[     5.625009] atkbd serio0: Unknown keypressed (translated set 2, code 0x67 on isa0060/serio0).
[     5.625071] atkbd serio0: Use 'setkeycodes 67 <keycode>' to make it known.
What could be wrong? If any of you need further information I will try to give it to you.
I can't even run the Live installer on the disk without receiving the above error like the recovery mode one.