Hey there, I have an HP stream 13. I'm attempting the Kali 2.0 installation, but running across some issues. I know that this device has a couple factory encrypted partitions on it which Kali 1.1 didn't seem to have an issue with. Anyways, I go through the install procedure, get to partition disk, and follow guided.

I am given the following information:
MMC/SD card #1 [mmcblk0] 31.3GB MMCMBG4GC
Primary at 29.9GB
swap at 1.3GB
/dev/mmcblk0boot0 4.2mb
/dev/mmcblk0boot1 4.2mb

When I press continue I'm told "The ext4 file system creation in partition #1 of MMC/SD card #1 [mmcblk0] failed.

dmesg says driver mmcblk needs updating please use bus_type methods. I have no idea if that's related to the issue. Other possible problems in dmesg
EXT4-fs mmcblk0p1: couldn't mount as ext[23]