Hello,

Basically i installed Kal 2.0 and i booted it up and it starts up with the display messages (or whatever verbose it goes through before booting into gui) showing on both screens then after it actually boots into the gui it will only display on the one graphics card. I have googled for the better half of two days and broken several installs hence the reason I'm finally sucking it up and asking for assistance. when i run lspci it shows that i have both graphics cards however when i go into the "settings" it only shows the one monitor. Also for further information both are running out of HDMI ports in the rear, also i have swapped the cards already around inside. It seems like the cards are automatically setup to run crossfire, however from what i have read linux doesn't support that. at any rate below are some of what i have for information.

"lspci | grep VGA"
Code:
04:00.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Oland XT [Radeon HD 8670 / R7 250]
05:00.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Oland XT [Radeon HD 8670 / R7 250]
"Xorg -version"
Code:
X.Org X Server 1.17.2
Release Date: 2015-06-16
X Protocol Version 11, Revision 0
Build Operating System: Linux 3.16.0-4-amd64 x86_64 Debian
Current Operating System: Linux kali 4.0.0-kali1-amd64 #1 SMP Debian 4.0.4-1+kali2 (2015-06-03) x86_64
Kernel command line: BOOT_IMAGE=/boot/vmlinuz-4.0.0-kali1-amd64 root=UUID=36293c21-34bf-4f99-b212-aceaebb0a0e4 ro quiet
Build Date: 01 July 2015  05:17:14PM
xorg-server 2:1.17.2-1 (http://www.debian.org/support) 
Current version of pixman: 0.32.6
	Before reporting problems, check http://wiki.x.org
	to make sure that you have the latest version
I am pretty new to linux in general but i can figure out for a good portion of how to work things, I would really appreciate any help!


THANK YOU!