REAVER - 3 simultaneous problems - still after 24 hours of research

[aanarchyy]

I apologize in advance for jumping into the middle of a discussion if it is inappropriate.....but i am having the same problem that MrVeryVeryGreen is having as far as the RSSI =00 on all the AP'S i scan when running Wash.....

I have Kali Linux installed on a laptop by itself with the wireless card removed that came with the laptop......

I have both the Alfa AWUS036NHA and the Alfa AWUS036NH wireless cards.....I am also using a 2.4GHz 24dBi Grid Parabolic Antenna.....

I have searched for a solution but have been unable to find anything until i read this thread.....I am hoping someone can provide an answer......

That is a chipset problem as far as i can tell. And as far as i know there is no work-around.
Some of mine do the same thing( which is one of the many reasons i chose to stop using
most of the reaver project).
Perhaps try airodump-ng --wps , not only does that actually give you a signal strength, but a LIVE signal strength...