Hello guys;

I hope this is the right section to post this.

somewhere there must be a bug in my brain, trying to set up and run the dhcp server on my kali linux 2.0 .
I always get the message "not configured to listen to any device" when starting dhcp server.

My dhcpd.conf:

Code:
authoritative;

subnet 192.168.0.0 netmask 255.255.255.0 
{
range 192.168.0.10 192.168.0.200; 
#Range of client's IP addresses: 10 to 200
option subnet-mask 255.255.255.0;
option broadcast-address 192.168.0.255;
option domain-name-servers 8.8.8.8;
option routers 192.168.0.1;
}
My isc-dhcp-server file:
Code:
INTERFACESv4="wlan0"
INTERFACESv6="wlan0"
My interfaces file:
Code:
auto lo
iface lo inet loopback

auto wlan0
iface wlan0 inet static
address 192.168.0.2
netmask 255.255.255.0
network 192.168.0.0
broadcast 192.168.0.255
gateway 192.168.0.1
I am connected at wlan0 with my router that has IP 192.168.0.1

route -n says:

Code:
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
0.0.0.0         192.168.0.1     0.0.0.0         UG    600    0        0 wlan0
0.0.0.0         192.168.0.1     0.0.0.0         UG    600    0        0 wlan1
192.168.0.0     0.0.0.0         255.255.255.0   U     600    0        0 wlan0
192.168.0.0     0.0.0.0         255.255.255.0   U     600    0        0 wlan1
ifconfig says:

Code:
eth0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        ether e0:db:55:e7:b0:81  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
        device interrupt 20  memory 0xf7e00000-f7e20000  

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 250  bytes 17184 (16.7 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 250  bytes 17184 (16.7 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.102  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 fe80::8e12:5b29:d4da:e612  prefixlen 64  scopeid 0x20<link>
        ether 60:67:20:a4:d7:0a  txqueuelen 1000  (Ethernet)
        RX packets 180229  bytes 248116063 (236.6 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 146258  bytes 18813716 (17.9 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlan1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.101  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 fe80::3da:9923:f491:87eb  prefixlen 64  scopeid 0x20<link>
        ether 00:c0:ca:76:4c:11  txqueuelen 1000  (Ethernet)
        RX packets 40336  bytes 30912546 (29.4 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 494  bytes 79771 (77.9 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
Thank you very much for your help!