AWUS036NH - Kali linux 2019.4 installed

[Ricksonk]

Hello my friends! How do you all make this adapter to work on kali linux? I've checked some reviews and people say that this adapter works well and the firmware rt3070 is recommended for kali linux.

But it keeps saying "device isn't ready" when I plug to my notebook. And if I turn on monitor mode and run airodump-ng, it can't find any AP.

The adapter is working pretty well on wifislax.




dmesg:

[ 852.262272] ieee80211 phy1: rt2x00_set_rt: Info - RT chipset 3070, rev 0201 detected
[ 852.274218] ieee80211 phy1: rt2x00_set_rf: Info - RF chipset 0005 detected
[ 852.274664] ieee80211 phy1: Selected rate control algorithm 'minstrel_ht'
[ 852.275525] usbcore: registered new interface driver rt2800usb
[ 852.332969] ieee80211 phy1: rt2x00lib_request_firmware: Info - Loading firmware file 'rt2870.bin'
[ 852.333201] rt2800usb 1-3:1.0: firmware: direct-loading firmware rt2870.bin
[ 852.333206] ieee80211 phy1: rt2x00lib_request_firmware: Info - Firmware detected - version: 0.29
[ 870.830733] wlan0: AP c4:6e:1f:60:5b:7a changed bandwidth, new config is 2437 MHz, width 1 (2437/0 MHz)
[ 873.800363] wlan0: AP c4:6e:1f:60:5b:7a changed bandwidth, new config is 2437 MHz, width 2 (2427/0 MHz)
[ 1197.043905] ieee80211 phy1: rt2x00usb_vendor_request: Error - Vendor Request 0x06 failed for offset 0x0404 with error -71
[ 1198.311077] ieee80211 phy1: rt2800_wait_csr_ready: Error - Unstable hardware
[ 1198.311092] ieee80211 phy1: rt2800usb_set_device_state: Error - Device failed to enter state 4 (-5)
[ 1235.991195] device wlan1 entered promiscuous mode
[ 1237.815688] device wlan1 left promiscuous mode




Injection:

aireplay-ng -9 wlan1
00:19:48 Trying broadcast probe requests...
00:19:50 No Answer...
00:19:50 Found 0 APs

[Mister_X]

I've seen similar behavior happen on VMware, with USB 3.0 ports. Switching to 2.0 solved the issue. Try plugging to a USB 2.0 and report back.

[Ricksonk]

I've seen similar behavior happen on VMware, with USB 3.0 ports. Switching to 2.0 solved the issue. Try plugging to a USB 2.0 and report back.

It is the same problem with USB 3.0 and USB 2.0.

[Mister_X]

Set the VM to automatically attach new USB to it, then plug it when the VM has focus.

[Ricksonk]

Set the VM to automatically attach new USB to it, then plug it when the VM has focus.

I'm not using VM, Kali Linux is installed in my notebook. Could this be the problem?

[sml156]

I've seen similar behavior happen on VMware, with USB 3.0 ports. Switching to 2.0 solved the issue. Try plugging to a USB 2.0 and report back.

By default VMware workstation pro only enables USB 2, You can change this in "VM > Settings > USB Controller" Select USB compatibility USB 3