Waveshare HDMI LCD 4" on 64bit Kali error during install

[OptX]

Hi, i got myself a Pi4 and i want to use the Waveshare Display. I tested it with rasbian buster and all went fine. When i did the same steps for kali, installation went so fast that i could not see what was going on, so i erased the 'sudo reboot' and got this :

root@kali:~/LCD-show# ./LCD4-800x480-show
Reading package lists... Done
Building dependency tree       
Reading state information... Done
xserver-xorg-input-evdev is already the newest version (1:2.10.6-1).
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
dpkg: error processing archive ./xinput-calibrator_0.7.5-1_armhf.deb (--install):
 package architecture (armhf) does not match system (arm64)
Errors were encountered while processing:
 ./xinput-calibrator_0.7.5-1_armhf.deb
Reading package lists... Done
Building dependency tree       
Reading state information... Done
Package cmake is not available, but is referred to by another package.
This may mean that the package is missing, has been obsoleted, or
is only available from another source

E: Package 'cmake' has no installation candidate
sudo: cmake: command not found
make: /usr/bin/cmake: Command not found
make: *** [Makefile:176: cmake_check_build_system] Error 127
LCD configure 0
reboot now

Is there something for 64bit allready ?

Will see what happens when i use 32bit Kali now....

[steev]

cmake exists - you'll want to run apt update before running their installer - but, they're expecting the drivers to be run on a 32bit system; you're either going to have to go through that installer script and run things manually (and skip the xinput configurator package - or try to build it, or check the waveshare wiki to see if they have manual instructions. All else fails, you can contact them and ask them to provide arm64 debs for the packages for people running 64bit (or you can switch to using the rpi 2/3/4 32bit image)

[WarrenKeller]

Great, I fixed that myself. thank you