I downloaded the 64bit image for the Raspberry PI 400, newest 2020.04 mentioning RPI 400. After booting, wifi does not show up, ifconfig does not list it.
How do I enable wifi?
I downloaded the 64bit image for the Raspberry PI 400, newest 2020.04 mentioning RPI 400. After booting, wifi does not show up, ifconfig does not list it.
How do I enable wifi?
if you can connect with ether cable, do so and then run apt upgrades, see if that helps
I am having the same issue. When i do an ifconfig i only get eth0 and lo. when i do iwconfig i get lo: no wireless extensions, eth0: no wireless extensions. I have gone into raspi-config and set wireless adapter region to US.
rebooted
HELP!!!!
I have the same issue.
Did you get this sorted out?
I know you need to get a usb wifi adapter like the Alfa AWUS036NHA for long range or similar that supports with Kali and works with the pi 400. I just ordered a Pi 400 and am planning the same thing and am in the process of getting a USB adapter for the 400 that will work. I am thinking of getting one that also supports USB 3.0 and 5 GHz like the Alpha AC1200 or similar like the Panda PAU09 N600 that I have read will work with Kali. Just wondering what you went with and if the 64 bit version worked well for you? I have read to use the 32 bit instead.
The following might work (it worked for me):
STEP 1:STEP 2:Code:cd /bootSTEP 3:Code:sudo touch wpa_supplicant.confSTEP 4: Type the following in the file in edit mode:Code:sudo vim wpa_supplicant.conf
country=gb
update_config=1
ctrl_interface=/var/run/wpa_supplicant
network={
scan_ssid=1
ssid="YourNetworkID"
psk="Password"
}Note: if you are living in the US or elsewhere you will need to change the country code.
STEP 5: Save and Exit edit mode, by clicking ESC, and typingto save your changes.Code:!wq
STEP 6: reboot your system by typing "reboot" on the command line.
After this you should be able to see Wifi is enabled.
The following might work (it worked for me):
STEP 1:STEP 2:Code:cd /bootSTEP 3:Code:sudo touch wpa_supplicant.confSTEP 4: Type the following in the file in edit mode:Code:sudo vim wpa_supplicant.conf
Note: if you are living in the US or elsewhere you will need to change the country code.Code:country=gb update_config=1 ctrl_interface=/var/run/wpa_supplicant network={ scan_ssid=1 ssid="YourNetworkID" psk="Password" }
STEP 5: Save and Exit edit mode, by clicking ESC, and typingto save your changes.Code:!wq
STEP 6: reboot your system by typing "reboot" on the command line.
After this you should be able to see that Wifi is enabled.