I'm having some problems with reaver. I have a internal Wifi Card that does not do Packet Injection RTL8188EE. In fact it runs absolutely horribly on Linux period. The other card I have does packet injection rt2800usb I bought specifically for Linux.
I wanted to do some security penetration on my own router and start learning more about Network Security. I have my A+ and Net+ I'd like to move onto Security certifications. I also need to learn more about Linux and get those Certs.
I will try to keep out repetitive information and limit the post as much as possible.
1) Run IfConfig note the Mac Address of existing Wifi Adapter, 1X:0X:bF:6X:1D:4X in this case
2) Insert Wifi Card.Run ifConfig again. Note which Wlan the new card is by the mac address. In My case it is Wlan1
3) airmon-ng start wlan1
Code:
Interface Chipset Driver
wlan1 Unknown rt2800usb - [phy1]
(monitor mode enabled on mon0)
wlan0 Unknown rtl8188ee - [phy0]
4) airodump-ng mon0
Code:
XX:XD:XE:X9:XC:X8 -32 2421 294 2 6 54 WPA TKIP PSK Lanane Family
X8:FX:BX:1X:XX:87 -62 3 0 0 1 54e WPA2 CCMP PSK PapaGrammyZim
FE:F5:28:A0:C8:F8 -66 1 0 0 10
So On ....
5) reaver -i mon0 -b XX:XD:XE:X9:XC:X8 -vv
I get .....
Code:
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family
)
6) I then tried aireplay-ng -9 wlan1
Code:
ioctl(SIOCSIWMODE) failed: Device or resource busy
ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start wlan1 <#>'
Sysfs injection support was not found either.
I then got a popup box asking for my network password. It then reconnected my wifi that was supposed to be in monitor mode.
Actually it looks like it connected my internal wifi, not the external USB one
Code:
oem-HP-15-Notebook-PC oem # iwconfig
mon0 IEEE 802.11bgn Mode:Monitor Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:on
wlan1 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
eth0 no wireless extensions.
lo no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"Lanane Family"
Mode:Managed Frequency:2.437 GHz Access Point: XX:XX:XX:XX:XX:XX
Bit Rate=1 Mb/s Tx-Power=20 dBm
Retry long limit:7 RTS thr=2347 B Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=62/70 Signal level=-48 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
7) After some tinkering around I typed in ... Typed in aireplay-ng -9 mon2
Code:
17:59:58 Trying broadcast probe requests...
17:59:59 Injection is working!
18:00:00 Found 1 AP
18:00:00 Trying directed probe requests...
18:00:00 XX:XX:XX:XX:XX:XX - channel: 6 - 'Lanane Family'
18:00:00 Ping (min/avg/max): 1.319ms/3.800ms/10.868ms Power: -34.55
18:00:00 29/30: 96%
Also if I test for packet injection by typing in aireplay-ng -9 wlan1 or aireplay-ng -9 wlan2 I get an error .... It only says I have packet injection when I check the mon not the wlan.
After doing all this I am still getting :
Code:
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
[!] WARNING: Failed to associate with XX:XD:XE:X9:XC:X8 (ESSID: Lanane Family)
The router is literally 10 feet away from me.