Hey, so I'm new to the forums and I was hoping I could have a little assistance here:
So, I am running a HDD installed with kali 1.06. I also have an Alfa awus036h v5 NIC.
The problem is when I go to do an injection test, it barely ever works.
The process I usually do is the following:
(mon0 is enabled with monitor mode)Code:# airmon-ng start wlan4
Then after that, then I usually kill the PIDs that may cause an issue. The processes are NetworkManager and wpa_suppliment
After that, I use iwconfig to make sure monitor mode is enabled and then ususally take the NIC down and change the channel - not always, but I do sometimes.
Then, i use the "aireplay-ng -9 wlan4" or "aireplay-ng -9 mon0" both which usually fail and go to "no answer". It is only when I change the channel to 6 that it starts to work, but then it only picks up my AP and it still has very low packets (usually around 5/30).
After playing around with it for a while, I found that if i use the the command "iwconfig wlan4 mode monitor" and do not kill any PIDs that injection shows up as working, but again, barely works on any APs (it works on a printer... lol).
The card is scanning fine for APs but often fails the injection test and fails to capture a 4-way handshake usually.
The card is brand new so I don't think it is an issue with the card. Also, my internal NIC on the laptop injects perfectly, so I don't think it is an issue with the APs around me. Is it possible I need to patch some of the drivers?
If anyone could help me out, I'd be extremely happy.