Hi Guys,
I have just upgraded my Core-i3 laptop with a 240GB SSD + 1TB HDD + 8GB RAM, and have installed Kali KDE [freshly downloaded and installed]
I was assuming that it would boot and run much faster than the usual but I think the setup was still the same as what I had previously had before the upgrade.
below is my current partition scheme:
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT
[SSD]
sda 8:0 0 223.6G 0 disk
├─sda1 8:1 0 487M 0 part /boot
└─sda2 8:2 0 139.7G 0 part /
[HDD]
sdb 8:16 0 931.5G 0 disk
├─sdb1 8:17 0 186.3G 0 part /home
├─sdb2 8:18 0 1K 0 part
├─sdb3 8:19 0 7.5G 0 part [SWAP]
├─sdb5 8:21 0 186.3G 0 part /usr
└─sdb6 8:22 0 186.3G 0 part /var
I already have the latest drivers/firmwares for the SSD.
I have moved mostly all the moving part on the HDD for storage purposes and had kept boot and / in SSD.
I also did some google searches on how to optimize the setup for the SSD, I have found some tips but i think it's still not that optimal.
below is my fstab configuration [still untouched]
# / was on /dev/sda2 during installation
UUID=0d017bdc-c312-4fd7-8d5a-96f7223ee953 / ext4 errors=remount-ro 0 1
# /boot was on /dev/sda1 during installation
UUID=89568a4b-11e4-4020-bedb-e5fc73ef5219 /boot ext2 defaults 0 2
# /home was on /dev/sdb1 during installation
UUID=97036e80-fdf0-4cb2-b75c-168fa4f3d99c /home ext4 defaults 0 2
# /usr was on /dev/sdb5 during installation
UUID=c5970950-f83f-4d96-9cda-6831b556996a /usr ext4 defaults 0 2
# /var was on /dev/sdb6 during installation
UUID=5fb32d8b-b58a-45ee-8083-46875d0d2208 /var ext4 defaults 0 2
# swap was on /dev/sdb3 during installation
UUID=ae7a7d11-3904-44c8-aa04-5d08592c3969 none swap sw 0 0
and also what I noticed is that when the system boots up a command prompt asking me to login on tty1 is displayed then after a minute the Logon GUI kicks in.
I would like to ask some of your insights on this and if possible kindly point me to the right thread [if there is something like that already] so I may learn how to properly setup the system optimally.
regards,