I have a wifi adapter that shows up when I type
As you can see hereCode:ip link show wlan0
If I runCode:3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000 link/ether 26:12:4e:8d:eb:9f brd ff:ff:ff:ff:ff:ffI see a list of available WiFi networks. When I typeCode:iw wlan0 scanit will not change the state from DOWN to UP.Code:ip link set wlan0 up
How can I enable this Wifi Adapter through the command line? (I only have terminal access at this moment)