serial output use baudrate 19200
Code:
ASIC-ROM_1.8
1. 40Mhz
2. post
3. eep chk
[%s+]
patch.offset: 0x%04x, patch.size : 0x%04x
[%s+]
CheckSum: 0x%08x
size: %d bytes
ld_addr: 0x%08x
fun_addr: 0x%08x
copy %d bytes from 0x%08x to 0x%08x[%s-]
[%s-]
4. cold start
5. usb only!!
6. read usb_conf(0x%04x) to ram(0x%08x)
7. usb_hclk rdy
8. download
- custom usb config
- custom usb config
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
[cUSB_REQ_DOWNLOAD]: 0x%08x, %02x
==>[cUSB_REQ_COMP]: 0x%08x
VendorCmd: DownloadComplete!
5. usb only!!
A_WDT_INIT()
==>cold start<==
ALLOCRAM start 0x50d80c size 106484
Enable Tx Stream mode: 0x30f
USB mode: 0xf
[+++Magpie_init]
[+++VBUF_init(100)]
[+++VBUF_init(100)]
<wlan_pci_probe>: Attaching the driver
<wlan_pci_probe>: Vendor id 0x168c Dev id 0x24
ath_pci_probe 24
ath_hal = 0x00510928
=>[dnQ] 0x0050f288
[ =>[upQ] 0x0050f264
[ =>[hp dnQ] 0x0050f240
[ =>[mp dnQ] 0x0050f21c
[Tgt running