Slim,
at different points when I have to click [enter] to start a scan, a second terminal window opens then closes again quickly. I just downloaded 3.2 and it is still doing it.
Slim,
at different points when I have to click [enter] to start a scan, a second terminal window opens then closes again quickly. I just downloaded 3.2 and it is still doing it.
slim... this may just be me... see below... it worked correctly this time when i chose to disable processes that might cause issues: Y
********************************************
Please choose an option?: 1
Available WiFi Adapters.
########################
1: wlan0
Please input the number of your chosen WiFi adapter: 1
#########################################
# FrankenScript #
#########################################
# #
# [1] Interface Selection #
# [2] System Mode Selection #
# [3] Attack A WPS Enabled Access Point #
# [4] Capture WPA/WPA2 Handshake #
# [5] WEP Attacks #
# [6] Attack Handshake.cap Files #
# [7] Show Recovered Passkeys #
# [8] Recovered Passkey Checker #
# #
#########################################
Chosen Interface: wlan0
System Mode: Networking Mode Is Enabled
MAC address for mon0:
Please choose an option?: 2
What system mode would you like to set.
[1] = Put The System Into Networking Mode.
[2] = Put The System Into Attack Mode.
[3] = Return To Menu.
1, 2 or 3?: 2
Would you like to disable processes that might cause issues y/n?: y
Would you like to disable NetworkManager y/n?: y
Would you like to disable wpa_supplicant y/n?: y
Found 2 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!
-e
PID Name
3051 dhclient
3057 dhclient
Interface Chipset Driver
wlan0 Broadcom b43 - [phy0]
(monitor mode enabled on mon0)
Permanent MAC: b8:8d:12:30:6b:f2 (unknown)
Current MAC: b8:8d:12:30:6b:f2 (unknown)
New MAC: 40:2d:60:68:79:8f (unknown)
#########################################
# FrankenScript #
#########################################
# #
# [1] Interface Selection #
# [2] System Mode Selection #
# [3] Attack A WPS Enabled Access Point #
# [4] Capture WPA/WPA2 Handshake #
# [5] WEP Attacks #
# [6] Attack Handshake.cap Files #
# [7] Show Recovered Passkeys #
# [8] Recovered Passkey Checker #
# #
#########################################
Chosen Interface: wlan0
System Mode: Attack Mode Is Enabled
MAC address for mon0: 40:2d:60:68:79:8f
Please choose an option?: 3
Scan for WPS enabled access points.
Press Ctrl+c on the wash screen to stop the scan and to choose a target.
Press [Enter] to launch the scan.