Go thru this thread you will find Musket Team comments on setting up this program. You cannot use the wifi device supporting the rogue to provide internet access read below
Suggest you first set up item 4 and do not provide internet access. Use another computer and see if you can:
1. See the rogue
2. Connect to the rogue
3. Bring up the web page
4. Pass data to the formdata.txt. file
Next use item 9 a. and provide internet access
You will need either two(2) wifi recievers or a wifi reciever for the rogue and a cable to provide internet access
If you use two wifi recievers one will support the rogue and one will provide the internet access.
The trick here is to know which is the rogue and which is providing said internet access
When the pwnstar program restarts network manager both wifi recievers may start searching and or connect to an AP. Let the wifi device that is providing internet access to connect to an AP and disconnect or make sure the wifi device supporting the rogue is idle. Read thru our comments in this thread it is all covered.
Continue the setup process and then test the four steps above again - You are now ready to catch a phish. However WPA phishing is different and you will need to read the help files and comments in this thread about channels and essid names.
Finally if you are using Kali 1.08 you will get a negative-one warning when first running airbase-ng BUT this doesnot seem to affect the operation.
MTC
